Aardvark Display Lighting 07753 796306

Microspot LED Display Light

The Microspot LED spotlights are ideal for display and exhibition lighting when style and functionality are both paramount.  The Microspot LEDs are a low voltage (12V) LED clip on spotlights manufactured in a polished anodised aluminium to give a chrome-like finish.  The head swivels through 180 degrees allowing you to achieve the best exhibition lighting. Microspot LED clip on spotlights are supplied with a 4 Watt GU5.3 (MR16) LED bulb which gives out a light roughly equal to a 20W halogen bulb.. 

The Microspot LED requires a 240/12v LED driver.

Microspot LED Tube Clamps (TC) are our most versatile, clip on spotlights, fitting tubes as well as boards.  With rubber grips and an adjustment from 5mm to 50mm this is ideal for clamping a light in those difficult positions


Microspot LED Bulldog Clip (BD) is the simplest of our clip on spotlights when speed of getting on and off is required.  The very strong bulldog clip can clip to boards from 5mm to 50mm




To directly mount onto a wall or ceiling we have four options:


Microspot LED Cabinet Plate (CP) is 25mm diameter with 3 screw holes.  This is ideal for mounting in cabinets or discretely on furniture or displays.



Microspot LED Ceiling Bracket (CB) is 74mm diameter with 4 screw holes.  This is ideal for built exhibition stands or shop fitting.








Microspot LED Cell Clamp (CC) is a simple right angled bracket with a hole in the base to bolt the light to a fixed surface (eg wall top or aluminium truss).  This provides a simple yet effective way to semi-permanently mount the light.

Microspot LED Wall Mount (WM) is designed to mount the light onto the top of a wall using 2 screws (not provided).  The arm can be mounted horizontally or tilted back above the horizontal using a simple tri-knob (un-tighten and re-tighten when in position)


To mount and dismantle your lighting we can offer the following nine removable options:

Microspot LED Economy Clamp (EC) is a simple clamp mechanism tightened from the rear using the circular knob.  The clip on spotlights clamp adjusts from 0mm - 57mm



Microspot LED Klamp-On (KO) is a robust versatile clamp allowing the arm and head to be positioned from horizontal to vertical as it comes out from the mount.  The klamp-on adjusts from 16mm to 60mm






Microspot LED Pop-on (PO) is designed for pop-up exhibition systems and simple clips under and over the cross members behind the graphics and is held in place by gravity.  So simple and easy to attach and take down it is the ideal complement to any pop-up system

Microspot LED Clip-on (CO / COMK / COSD) is a simple cantilevered clip for shell-schemes, aluminium profile exhibition systems and board systems with grooves.  Slotted into the groove or profile the light is simply held in place by gravity.  Very simple to use.  Call us to confirm the clip required








Microspot LED Banner Bung (BB) was designed for simple insertion into exhibition banners which have a hole in the upright pole.  Because of their simplicity they can also be used in some aluminium profile exhibition systems and in any built stand by drilling a hole into the mounting point.  Available in 8, 10, 12, 14mm bottom diameter







Microspot LED Slot Over (SO) is a saddle which slots over a board or profile.  Easy on: easy off





Microspot LED Slot In (SI) is designed with 2 flat prongs to slot into the Nomadic exhibition system