Aardvark Display Lighting 07753 796306

Janus LED - Exhibition Display Lighting

The Janus LED  exhibition display lighting are Italian styled cast aluminium single spotlights, ideal for a multitude of applications in the exhibition and display industry.   These single spotlights are an ideal solution when a simple yet stylish look is needed.  Janus LED exhibition display lighting uses the MR16 LED bulb.  Finished in matt-aluminium or matt-black the head swivels through 180 degrees allowing excellent versatility.  The Janus LED exhibition display lighting is a powerful tool in the designers armoury.

The Janus requires a 240/12v LED driver: a tiny transformer like electronic driver.

To directly mount onto a wall or ceiling we have four options:

Janus LED Cabinet Plate (CP) is 25mm diameter with 3 screw holes.  This is ideal for mounting in cabinets or discretely on furniture or displays.


Janus LED Ceiling Bracket (CB) is 74mm diameter with 4 screw holes.  This is ideal for built exhibition stands or shop fitting.









Janus LED Cell Clamp (CC) is a simple right angled bracket with a hole in the base to bolt the light to a fixed surface (eg wall top or aluminium truss).  This provides a simple yet effective way to semi-permanently mount the light.

Janus LED Wall Mount (WM) is designed to mount the light onto the top of a wall using 2 screws (not provided).  The arm can be mounted horizontally or tilted back above the horizontal using a simple tri-knob (un-tighten and re-tighten when in position)


To mount and dismantle your lighting we can offer the following nine removable options:


Janus LED Economy Clamp (EC) is a simple clamp mechanism tightened from the rear using the circular knob.  The clamp adjusts from 0mm - 57mm


Janus LED Klamp-On (KO) is a robust versatile clamp allowing the arm and head to be positionned from horizontal to vertical as it comes out from the mount.  The klamp-on adjusts from 16mm to 60mm







Janus LED Tube Clamp (TC) is our most versatile clamp, fitting tubes as well as boards.  With rubber grips and an adjustment from 5mm to 50mm this is ideal for clamping a light in those difficult positions




Janus LED Bulldog Clip (BD) is the simplest clip when speed of getting on and off is required.  The very strong bulldog clip can clip to boards from 5mm to 50mm








Janus LED Pop-on (PO) is designed for pop-up exhibition systems and simple clips under and over the cross members behind the graphics and is held in place by gravity.  So simple and easy to attach and take down it is the ideal complement to any pop-up system


Janus LED Clip-on (CO / COMK / COSD) is a simple cantilevered clip for shell-schemes, aluminium profile exhibition systems and board systems with grooves.  Slotted into the groove or profile the light is simply held in place by gravity.  Very simple to use.  Call us to confirm the clip required





Janus LED Banner Bung (BB) was designed for simple insertion into exhibition banners which have a hole in the upright pole.  Because of their simplicity they can also be used in some aluminium profile exhibition systems and in any built stand by drilling a hole into the mounting point.  Available in 8, 10, 12, 14mm bottom diameter









Janus LED Slot Over (SO) is a saddle which slots over a board or profile.  Easy on: easy off





Janus LED Slot In (SI) is designed with 2 flat prongs to slot into the Nomadic exhibition system